← Back to the full entry
Sinn 104 St Sa I MG
Reference 104.0131. A sheet to take with you: the numbers to check the watch against, what to look at, and what to ask. It does not authenticate anything and it does not tell you whether to buy.
Check the numbers
Measure or ask. A watch that does not match these is not necessarily wrong, but it is a question worth the answer.
| Case width | 41mm |
|---|
| Thickness | 11.9mm |
|---|
| Lug to lug | the brand publishes none |
|---|
| Strap width | 20mm |
|---|
| Water resistance | 200m |
|---|
| Case material | steel |
|---|
| Crystal | sapphire |
|---|
| Bezel | steel |
|---|
| Produced | the brand publishes no dates |
|---|
| Movement | Sellita SW220-1: Swiss automatic, ETA 2836-2 functional equivalent, 28,800bph, 26j; day and date, the day-date sibling of the SW200-1 |
|---|
Anything above marked not recorded is a gap in this catalog, not a property of the watch. Do not read a blank as a zero.
Before anything else
Sinn is not a meaningful counterfeit target, and the 104 is one of its most straightforward watches. The checks worth doing are about the movement and the bezel, not about the watch being genuine.
What to look at
- case Bezel rotation
Correct Turns in both directions with a defined click through the full rotation
Red flag Rotation in one direction only, or a bezel that turns freely with no click
- movement Caliber SW220-1 day and date quickset
Correct Both day and date advance independently from the crown and change fully at midnight
Red flag Either indication failing to quickset, or a changeover spread over more than a few minutes
- dial Metallic green surface and printing
Correct Even metallic green across the dial with crisp white printing and no bleed at the edges
Red flag Blotchy or dulled areas, which on a watch this recent usually means moisture ingress
- crown Screw-down crown and 200m seal
Correct Crown threads cleanly and seats fully; the 20 bar rating depends on it
Red flag Cross-threading or a crown that will not seat, which is both a fault and a water-ingress risk
Known issues on this reference
- The 104 carries a bidirectional pilot's bezel, not a unidirectional dive bezel. A 104 that only turns one way has had its bezel or its click spring changed.
- The Sellita SW220-1 drives both day and date. A quickset that advances the date but not the day, or the reverse, is a movement fault rather than a variant.
- The metallic-green dial is specific to the 104.0131. A green 104 offered under any other product number is a different watch or a mislabelled listing.
Parts that are commonly replaced
- Straps and bracelets are swapped routinely on a 20mm lug width.
- Crystals and crown gaskets are ordinary service parts.
Ask the seller, whatever the watch
- When was it last serviced, by whom, and is there paperwork?
- Has the case ever been polished?
- Which parts are not original to it?
- Do you have the box, papers and the original bracelet or strap?
- Why are you selling it?
- Can I see it in daylight, and can I take a photo of the caseback?
What this sheet is standing on
The specifications above are sourced to sinn.de. What else the catalog does not know.
← Back to the full entry · General inspection checklist